Main thread cutting dictates

  • Time:
  • Click:322
Graph method of main thread cutting sees cutting of 1 columnar whorl the graph is shown 1 times. In type of G32 X(U)~ Z(W)~ F~ of process designing format: The terminal coordinate of cutting of whorl of X(U) , Z(W) - is worth; Columnar whorl cutting is when X omits, cutting of end panel whorl is when Z omits; Awl whorl cutting is when X, Z all does not omit; (X coordinate is worth a basis " mechanical design manual " check a watch to decide) lead of F - whorl. Whorl cutting should notice to install litre of enough fast feed in two end paragraph δ 1 and fall fast retreat a knife paragraph δ 2. Exemple: Try write the machine program that the graph shows thread 1 times. (whorl lead 4mm, rise fast feed paragraph δ 1=3mm, fall fast retreat a knife paragraph δ 2=1.

5mm, whorl deepness 2.

165 Mm) . ... G00 U-62 G32 W-74.

5F4 G00 U62 W74.

5U-64G32 W-74.

5G00 U64W74.

5... graph exemple of cutting of 2 conic whorl: Try write the machine program that the graph shows conic thread 2 times. (whorl lead 3.

5mm, rise fast feed paragraph δ 1=2mm, fall fast retreat a knife paragraph δ 2=1mm, whorl deepness 1.

0825 Mm) . G00 X12G32 X41 W-43 F3.

5G00 X50W43 X10 G32 X39 W-43G00 X50W43 CNC Milling